Pathfinder 4WD V6-4.0L (VQ40DE) (2006)
7. Disconnect steering outer socket from steering knuckle using Tool. Be careful not to damage outer socket boot.
Tool number: HT72520000 (J-25730-A)
CAUTION: To prevent damage to threads and to prevent Tool from coming off suddenly, temporarily tighten nut.
8. Remove wheel hub and bearing assembly bolts using power tool.
9. Remove splash guard and wheel hub and bearing assembly from steering knuckle.
CAUTION: Do not pull on wheel sensor harness.
10. Remove cotter pin and nut from upper link ball joint.
11. Separate upper link ball joint from steering knuckle using Tool.
Tool number: ST29020001 (J-24319-01)
12. Remove pinch bolt from steering knuckle using power tool, then separate lower link ball joint from steering knuckle.
13. Remove steering knuckle from vehicle.
INSPECTION AFTER REMOVAL
Check for deformity, cracks and damage on each part, replace if necessary.
^
Perform ball joint inspection. Refer to FSU-15, "Inspection". See: Ball Joint/Service and Repair/Front Suspension/Upper Ball Joint and Lower
Ball Joint
INSTALLATION