nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Interior - Door Window Wind/Squeak/Pop Noise|Page 13007 > < To VIN # 350000|Page 12998
Page 1
background image

Technical Service Bulletin # 00-028

Date: 000314

Interior - Door Window Wind/Squeak/Pop Noise

Classification:
BT99-053

Reference:
NTB00-028

Date:
March 14, 2000

1998-1999.5 PATHFINDER WIND/SQUEAK/POP NOISE FROM FRONT DOOR WINDOW AREA

APPLIED VEHICLES:
1998-1999.5 Pathfinder (R50)

SERVICE INFORMATION
 
If any of the following noises are heard from the front driver and/or passenger side window of a 1998-1999.5 Pathfinder, the window may not have
enough clearance to operate properly in the door channel:
 
^

Wind leak noise at the upper B-Pillar.

^

Window squeak during initial opening and at the top of travel/close.

^

Creaking or popping noise after the window is initially closed.

 
A new soft foam run rubber seal is available to correct this condition, if it should occur.
 
Use the information in this bulletin to diagnose the condition, remove the existing hard foam rope seal from the glass run rubber, and install the new soft
foam run rubber seal in its place.

PARTS INFORMATION

CLAIMS INFORMATION
 

Submit a Primary Failed Part (PP) line using the claims coding.
 

Service Procedure

DIAGNOSIS:
 
1.

Confirm that one of the noises exists as described in the bullet points above.

2.

Verify the condition of insufficient window clearance by applying a solution of soapy water into the glass run rubber area at the bottom of the
A-Pillar/door mirror.  Cycle the window up/down/up.

 

A.

If the noise still exists after the soapy solution is applied, this bulletin does not apply.  Investigate for other causes of the noise.

B.

If the noise is gone, use the Repair procedure provided below to resolve the incident.

Interior - Door Window Wind/Squeak/Pop Noise|Page 13007 > < To VIN # 350000|Page 12998