Pathfinder LE 4WD V6-3.3L (VG33E) (1997)
/Page-2117001.png)
Load Sensing Valve: Service and Repair
CAUTION:
^
Refill with new "DOT 3" brake fluid.
^
Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with
water immediately.
Load Sensing Valve (LSV) Components
REMOVAL AND INSTALLATION
1. Refer to illustration for removal and installation. Replace damaged dual load sensing valve as an assembly.
2. Do not reuse load sensing valve once it has been disassembled.
3. Torque all flare nuts to 15 - 17 Nm (11 - 13 ft. lb.)
4. Refill until new brake fluid comes out of each bleeder valve.
5. Bleed air from the hydraulic system. See: Brake Bleeding/Service and Repair
