Pathfinder LE 4WD V6-3.3L (VG33E) (1997)
/Page-2275003.png)
11. Remove rack bushing and rack oil seal using tape wrapped socket and extension bar.
CAUTION: Do not scratch inner surfaces of pinion housing.
INSPECTION
Thoroughly clean all parts in cleaning solvent or automatic transmission fluid type DEXRON IIE, DEXRON III or equivalent. Blow dry with
compressed air, if available.
Boot
^
Check condition of boot. If cracked excessively, replace it.
^
Check boots for accumulation of power steering fluid.
Rack
^
Thoroughly examine rack gear. If damaged, cracked or worn, replace it.
Pinion Assembly
^
Thoroughly examine pinion gear. If pinion gear is damaged, cracked or worn, replace it.
^
Check that all bearings roll freely. Ensure that balls, rollers and races are not cracked, pitted or worn.
Gear Housing Cylinder
^
Check gear housing cylinder bore for scratches or other damage. Replace if necessary.
Tie Rod Outer And Inner Sockets
^
Check Swinging Force "A":
Tie Rod Inner: 3.9 - 32.4 N (0.9 - 7.3 lbs.)
Tie Rod Outer: 4.9 - 47.1 N (1.1 - 10.6 lbs.)
^
Check Rotating Torque "B":
Outer: 0.3 - 2.9 Nm (2.6 - 26.0 inch lbs.)
^
Check Axial End Play "C":
Inner: 0.3 mm (0.012 inch) or less
Outer: 0.1 mm (0.004 inch) or less
^
Check condition of dust cover. If cracked excessively, replace outer tie rod.
ASSEMBLY
1. Using a heat gun, heat new teflon rack seal ring to approximately 40° C (104° F). Then place it onto rack.
