Pathfinder LE 4WD V6-3.3L (VG33E) (1997)
/Page-2281006.png)
17. While adjusting rear cover, measure rotating torque of input and output shaft (as a unit) with Tools. The rotating torque should be 0.25 - 0.69 Nm
(2.2 - 6.1 inch lbs.).
18. While holding rear cover with a pin-type nut wrench, tighten lock nut to 78 -118 Nm (58 - 87 ft. lbs.).
19. Check rotating torque 360° in both direction. If rotating torque is out of specification, loosen lock nut and repeat steps 17 and 18.
NOTE: If rotating torque is out of specification, rotate input shaft two turns clockwise, then two turns counterclockwise. Repeat this step 9 times.
The turning torque will then meet specification due to conditioning.
20. Install snap ring in the groove correctly. When the snap ring is installed correctly, about 2 mm (0.08 inch) gap exists at the snap ring ends.
CAUTION: Do not spread snap ring end gap more than 7 mm (0.28 inch) or else the snap ring will fatigue.
