Pathfinder LE 4WD V6-3.3L (VG33E) (1997)
^
Replace joint assembly if it is deformed or damaged.
ASSEMBLY
NOTE:
^
Use Nissan Genuine Grease or equivalent.
Final Drive Side (TS82F)
1. Install new small boot band, boot and side joint housing to drive shaft.
CAUTION: Cover drive shaft serration with tape so as not to damage boot during installation.
2. Install spider assembly securely, ensuring marks are properly aligned. Press-fit with spider assembly serration chamfer facing shaft.
3. Install new snap ring.
4. Pack with 95 - 105 grams (3.35 - 3.70 ounce) grease.
5. Make sure that boot is properly installed on the drive shaft groove. Set boot so that it does not swell and deform when its length is "L1".
Length "L1": 95 - 97 mm (3.74 - 3.82 inch)
6. Lock new larger boot band securely with a suitable tool, then lock new smaller boot band.