Pathfinder SE 4WD V6-3.5L (VQ35) (2002)
^
It is not necessary to remove any coolant hoses or drain the coolant during ignition coil removal.
6.
Replace the resistor assembly in all ignition coil tubes as follows:
A.
Pull the rubber boot away from the ignition coil. Then, twist and pull the ignition coil tube from the ignition coil to separate them (see
Figure 7).
B.
Remove the old resistor assembly parts from the ignition coil tube and discard. Insert the new resistor assembly into the ignition coil tube in
the order shown in Figure 8 shown.
C.
Assemble the ignition coil tube to the ignition coil.
^
Rotate the tube while pressing onto the coil.
^
A "pop" sound will be heard when the rubber boot is seated correctly to the ignition coil.