nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Recall - Driver Air Bag Connector Clip Installation|Page 9300 > < Recall - Driver Air Bag Connector Clip Installation|Page 9298
Page 5
background image

15.

From the passenger side, turn the ignition key to the ON position.

a.

If the Air Bag Module Warning Light turns OFF after 5 - 7 seconds, proceed to "Final Steps".

b.

If the Air Bag Module Warning Light does NOT turn ON at first, does NOT turn OFF, or blinks, refer to the applicable Service Manual for
diagnosis/repair. Then proceed to "Final Steps".

Final Steps:

16.

Re-program all radio station presets.

17.

Re-set the clock.

18.

Use CONSULT-II to clear any related DTC codes.

Xterra

Preliminary Steps:

1.

Write down all radio station presets.

2.

Remove any accessory (phone charger, etc.) from the 12V Power Outlet(s).

WARNING:

^

Do NOT use a "Computer Memory Save" (9-volt power source), that plugs into the 12V Power Outlet(s), to retain memory settings on the
computer and radio.

^

No voltage should be present in the system when performing this procedure.

3.

Disconnect both battery cables.

4.

Wait 3 minutes before proceeding with the following steps.

Reposition Driver's SRS Air Bag Module:

5.

Use a suitable plastic pry tool to carefully remove the:

^

Audio Controls Cover on the steering wheel (if equipped). See Figure 7. 

^

Automatic Speed Controls Cover or the steering wheel (if equipped) See Figure 7.

Recall - Driver Air Bag Connector Clip Installation|Page 9300 > < Recall - Driver Air Bag Connector Clip Installation|Page 9298