Pathfinder SE 4WD V6-3.5L (VQ35) (2002)
/Page-112001.png)
Fuel Gauge Sender: Testing and Inspection
Fuel Warning Lamp Sensor Check
1. Turn ignition switch "OFF".
2. Disconnect fuel level sensor unit harness connector B12.
3. Connect a resistor (80 Ohm) between fuel tank gauge unit harness connector terminals 2 and 3.
4. Turn ignition switch "ON".
The fuel warning lamp should come on.
NOTE: ECM might store the 1st trip DTC P0180 during this inspection. If the DTC is stored in ECM memory, erase the DTC after reconnecting
fuel tank gauge unit harness connector.
Refer to "HOW TO ERASE EMISSION-RELATED DIAGNOSTIC INFORMATION".
