Pathfinder XE 2WD V6-3.3L (VG33E) (1997)
CAUTION: Suspend caliper assembly with wire so as not to stretch brake hose.
3. Rotate caliper body upward. Then remove pad retainers and inner and outer shims. Always replace shims when replacing pads. If shims are rusted
or show peeling of the rubber coating, replace them with new shims.
4. Standard pad thickness is 11.0 mm (0.44 inches).
5. Pad wear limit is 2.0 mm (0.079 inches).
^
Carefully monitor brake fluid level because brake fluid will return to reservoir when pushing back piston.
INSTALLATION
1. Install caliper assembly.
Installing Caliper Assembly & Brake Hose
2. Install all parts and secure all bolts.
CAUTION:
^
Refill with new "DOT 3" brake fluid.
^
Never reuse drained brake fluid.
^
Use brake fluid to clean. Never use mineral oil.
3. Bleed air from the hydraulic system. See: Brake Bleeding/Service and Repair