Pathfinder XE 2WD V6-3.3L (VG33E) (1997)
c. Place mating surface of valve facedown, and remove internal parts.
-
If a valve is hard to remove, lightly tap valve body with a soft hammer.
-
Be careful not to drop or damage valves, sleeves, etc.
-
4-2 sequence valve and relay valve are located far back in upper body. If they are hard to remove, carefully push them out using stiff wire.
-
Be careful not to scratch sliding surface of valve with wire.
INSPECTION
Valve Springs
-
Measure free length and outer diameter of each valve spring.Also check for damage or deformation.
-
Replace valve springs if deformed or fatigued.
Control Valves
-
Check sliding surfaces of valves, sleeves and plugs.
ASSEMBLY
1. Lubricate the control valve body and all valves with ATF. Install control valves by sliding them carefully into their bores.
-
Be careful not to scratch or damage valve body.