nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

TCM - 1st to 2nd Gear Shift Flare|Page 8431 > < A/T - 1st to 2nd or 2nd to 3rd Gear Shift Flare|Page 8426
Page 1
background image

Control Module: All Technical Service Bulletins
TCM - 1st to 2nd Gear Shift Flare

Classification:
AT00-009

Reference:
NTB00-084

Date:
October 16, 2000

2001 PATHFINDER AUTOMATIC TRANSMISSION 1-2 SHIFT FLARE

APPLIED VEHICLES:
2001 Pathfinder (R50) - with Automatic Transmission

APPLIED VINS:
Vehicles built before:
JN8DR07X*1W507567 and
JN8DR07Y*1W505159

APPLIED DATE:
Vehicles built before April 20, 2000

SERVICE INFORMATION

If a customer indicates the automatic transmission flares on the 1-2 shift when accelerating hard from a stop and then backing off on the throttle, the
Transmission Control Module (TCM) may need to be replaced.

Should a customer advise this condition exists, use the Service Procedure in this bulletin to verify the incident, and (if verified), correct by replacing the 
TCM as indicated.

SERVICE PROCEDURE

1.

Use CONSULT-II to confirm there are no transmission codes stored. If codes are stored, correct as necessary before proceeding.

2.

Check transmission fluid level. Adjust as necessary before proceeding.

3.

Verify the incident by performing the following test drive in an open area:

A.

Accelerate from a full stop with 1/2 to 3/4 throttle application.

B.

As the rpm reaches 3000 to 3500, release the throttle slightly.

C.

Verify the transmission flares into 2nd gear.

4.

Install the replacement Transmission Control Module (TCM) listed in the PARTS INFORMATION section below.

5.

Repeat the test drive in steps 3A through 3C to confirm the incident has been resolved.

PARTS INFORMATION

CLAIMS INFORMATION

Submit a Primary Failed Part (PP) line claim using the claims coding table shown.

TCM - 1st to 2nd Gear Shift Flare|Page 8431 > < A/T - 1st to 2nd or 2nd to 3rd Gear Shift Flare|Page 8426