PL720 2WD L4-1952cc 2.0L SOHC (Z20) (1985)
/Page-686001.png)
Torsion Bar: Service and Repair
1.
Raise and support vehicle.
2.
Remove wheel.
3.
Remove torsion bar nuts.
4.
Remove dust cover, then disconnect snap ring from anchor arm.
5.
On 2WD models, pull anchor arm rearward, then remove torsion bar spring rearward. Remove torque arm.
6.
On 4WD models, remove torque arm attaching nuts, then pull torsion bar spring forward and remove with torque arm.
7.
Reverse procedure to install.
