PL720 2WD L4-2488cc 2.5L DSL (SD25) (1985)
Turn Signal Switch: Customer Interest
Instruments - Early Turn Signal Cancellation
Reference:
TECHNICAL BULLETIN TS86-100 Date: June 9, 1986
Classification:
BE86-011 Section: Body Electrical Models: 1985 720 Truck
EARLY TURN SIGNAL CANCELLATION, 1985 720 TRUCK
APPLIED MODEL: 1985 720 Truck
SERVICE INFORMATION
The turn signals of some 1985 720 Trucks may cancel early. To correct this condition on incident vehicles, use the following procedure to install a
combination switch spacer (P/N 25162-80W00).
PARTS INFORMATION
PART DESCRIPTION
PART NUMBER
Combination Switch Spacer
25162-80W00
Steering Wheel and Steering Column
SERVICE PROCEDURE
1.
Remove the steering wheel and steering column covers (lower and upper).
2.
Loosen the combination switch retaining screw.
Switch Spacer
3.
Install the combination switch spacer as shown below.
4.
Tighten the retaining screw while making sure the protrusion on the switch clamp is in the hole on the jacket tube.
5.
Install the steering column covers and steering wheel. See Section ST of the 1985 720 Service Manual for installation procedures.
WARRANTY INFORMATION
CS
PNC
CT
OP CODE
FLAT RATE
4Q
25160
34
PC14AA
0.5/hr.