Quest V6-3.5L (VQ35DE) (2009)
Door Locks: Service and Repair
SLIDE DOOR LOCK
Removal and Installation
OUTSIDE HANDLE
1. Remove the sliding door finisher. Refer to See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair.
2. Remove the grommet, and the outside handle escutcheon bolt (TORX T30) from grommet hole.
3. While pulling the outside handle (1), remove outside handle escutcheon (2).
4. While pulling outside handle (1), slide toward rear of vehicle to remove (2).
5. Remove the front gasket and rear gasket.