Quest V6-3.5L (VQ35DE) (2009)
Headlamp Bulb: Service and Repair
Headlamp (For USA)
HEADLAMP (FOR USA)
Bulb Replacement
CAUTION:
-
Do not touch bulb by hand right after being turned off. Burning may result.
-
Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from it.
-
Do not leave bulb out of front combination lamp assembly for a long time because dust, moisture, smoke, etc. may affect the performance
of the lamp. When replacing headlamp bulb, be sure to replace it with a new one.
-
After installing the bulb, be sure to install the bulb socket securely to ensure watertightness.
HEADLAMP (OUTER SIDE), FOR LOW BEAM
Removal
1. Turn headlamp switch OFF.
2. Disconnect the electrical connector.
3. Turn bulb socket counterclockwise and remove bulb.
Installation
Installation is in the reverse order of removal.
HEADLAMP (INNER SIDE), FOR HIGH BEAM
Removal
1. Turn headlamp switch OFF.
2. Disconnect the electrical connector.
3. Turn bulb socket counterclockwise and remove bulb.
Installation
Installation is in the reverse order of removal.
FRONT TURN SIGNAL/PARKING LAMP
Removal
1. Turn the front turn signal/parking lamp bulb socket counterclockwise to unlock it.
2. Pull bulb to remove it from socket.
Installation
Installation is in the reverse order of removal.