nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Technician Safety Information|Page 1950 > < Technician Safety Information
Page 1
background image

Information Bus: Vehicle Damage Warnings

CAN

PRECAUTIONS

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage
front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag,
depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the Restraint Systems information.

WARNING:
-

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would
result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.

-

Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional
activation of the system. For removal of Spiral Cable and Air Bag Module, see the "SUPPLEMENTAL RESTRAINT SYSTEM".

-

Do not use electrical test equipment on any circuit related to the SRS unless instructed. SRS wiring harnesses can be identified by yellow
and/or orange harnesses or harness connectors.

CAN Fundamental

PRECAUTIONS

Precaution for Harness Repair

-

Solder the repaired area and wrap tape around the soldered area.

NOTE:  A fray of twisted lines must be within 110 mm (4.33 in).

-

Bypass connection is never allowed at the repaired area.

NOTE:  Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

-

Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.

CAN

PRECAUTIONS

Precaution for Harness Repair

Technician Safety Information|Page 1950 > < Technician Safety Information