Quest V6-3.5L (VQ35DE) (2009)
Blower Motor Switch: Service and Repair
Removal And Installation
VARIABLE BLOWER CONTROL
Removal and Installation
VARIABLE BLOWER CONTROL (FRONT)
Removal
1. Remove the instrument lower panel RH and glove box. Refer to See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair.
2. Remove the center stack trim panel. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Center Stack Trim Panel.
3. Disconnect the variable blower control (front) electrical connector.
4. Remove the two screws and remove the variable blower control (front).
Installation
Installation is in the reverse order of removal.
VARIABLE BLOWER CONTROL (REAR)
Removal
1. Remove the rear lower finisher assembly. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair.
2. Disconnect the variable blower control (rear) electrical connector.
3. Remove the two screws and remove the variable blower control (rear).
Installation
Installation is in the reverse order of removal.