Quest V6-3.5L (VQ35DE) (2009)
Steering Angle Sensor: Service and Repair
STEERING ANGLE SENSOR
Removal and Installation
REMOVAL
1. Remove the spiral cable. Refer to See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair.
2. Remove the screws (A) and release clips (B) to remove the steering angle sensor (1) from spiral cable (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
In the case that the ABS actuator and electronic unit (control unit) is replaced, make sure to adjust position of steering angle sensor. Refer to
See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning.