Quest V6-3.5L (VQ35DE) (2009)
Power Steering Pump: Removal and Replacement
Removal and Installation
POWER STEERING OIL PUMP
Removal and Installation
REMOVAL
1. Remove wheel and tire using power tool.
2. Remove side splash guard.
3. Remove heat insulator.
4. Loosen adjustment screw and oil pump bolt, then remove belt.
5. Drain power steering fluid.
6. Remove power steering oil pump union bolt and hose.
7. Remove power steering oil pump bracket bolts.
8. Remove power steering oil pump.
INSTALLATION
Installation is in the reverse order of removal.
-
Tighten component connections to specification. Refer to See: Disassembly and Assembly.
-
Adjust belt tension. Refer to See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Testing and
Inspection.
-
Refill power steering system and bleed air after installation. Refer to See: Service and Repair See: Testing and Inspection/Component Tests and
General Diagnostics/Checking Fluid Leakage See: Power Steering Fluid/Service and Repair/Checking Fluid Level.
Disassembly and Assembly