Quest V6-3.5L (VQ35DE) (2009)
6. Install boot securely into grooves (indicated by * marks) as shown.
CAUTION:
If there is grease on boot mounting surfaces (indicated by *
marks) of shaft and housing, boot may come off. Remove all grease from surfaces.
7. Make sure boot installation length "L" is the specified length indicated below. Insert a flat-bladed screwdriver or similar tool into the large end of
boot. Bleed air from boot to prevent boot deformation.
Boot installation length "L" : 163 mm (6.42 in)
CAUTION:
-
Boot may break if boot installation length is less than standard value.
-
Be careful that screwdriver tip does not contact inside surface of boot.
8. Install new large and small boot bands securely using Tool.
Tool number : KV40107300 ( - )
NOTE:
Do not reuse boot bands.
CAUTION:
-
Secure boot band so that dimension "M" meets specification as shown.
Dimension "M" : 1.0 - 4.0 mm (0.039 - 0.157 in)
9. After installing housing and shaft, rotate boot to check whether or not the actual position is correct. If boot position is not correct, remove old boot
bands then reposition the boot and secure with new boot bands.
Damper