Quest V6-3.5L (VQ35DE) (2009)
Windshield Washer Reservoir: Service and Repair
Front Wiper And Washer System
FRONT WIPER AND WASHER SYSTEM
Washer Fluid Reservoir
REMOVAL
1. Remove fender protector. Refer to See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair.
2. Remove the washer fluid reservoir (2) from the vehicle.
-
Twist and pull out washer fluid reservoir inlet (1).
-
Remove front and rear washer motor electrical connector (3) and washer fluid level sensor electrical connector.
-
Remove washer fluid reservoir screws (A).
-
Remove front and rear washer hoses.
INSTALLATION
Installation is in the reverse order of removal.
Washer fluid reservoir screws : 5.5 N.m (0.56 kg-m, 49 in-lb)
CAUTION:
After installation, add water up to the upper level of the washer fluid reservoir inlet, and check for water leaks.