Quest V6-3.5L (VQ35DE) (2009)
Wiper Arm: Service and Repair
REAR WIPER AND WASHER SYSTEM
Rear Wiper Arm
REMOVAL
1. Operate rear wiper motor one full cycle, then turn OFF (auto stop).
2. Remove wiper arm cover, remove wiper arm nut, then remove rear wiper arm.
INSTALLATION
1. Prior to rear wiper arm installation, operate wiper motor one full cycle then turn OFF (auto stop).
-
Operate wiper motor one full cycle, then turn OFF (auto stop).
-
Using a suitable brush, clean pivot area as shown. This will reduce the possibility of wiper arm looseness.
2. Install rear wiper arm onto pivot and ensure wiper blade is parallel to the ground.
3. Tighten wiper arm nut to specification, install wiper arm cover.
Wiper arm nut : 15.5 N.m (1.6 kg-m, 11 ft-lb)