nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Engine Controls - No Start At Low Ambient Temperature|Page 2428 > < Oxygen Sensor - Thread Cleaning and Other Precautions|Page 2416
Page 1
background image

Technical Service Bulletin # 98-025

Date: 980315

Engine Controls - No Start At Low Ambient Temperature

Classification:
EC97-045

Reference:
NTB98-025

Date:
March 15, 1998

1997 QUEST NO START AT LOW AMBIENT TEMPERATURE

APPLIED VEHICLE:
1997 Quest (V40)

SERVICE INFORMATION
 

Cold Weather Starting Tips

If starting the engine of a 1997 Quest is difficult after an overnight cold soak at low temperature and high altitude conditions,  the cause may be an
excessively rich fuel mixture due to altitude and climate conditions.  Refer to Product Service Bulletin PI95-005 for "Cold Weather Starting Tips", and
print the information for the customer. 

If the vehicle remains difficult to start after applying the starting tips, a countermeasure ECM is available which will adjust the fuel mixture enrichment
during cranking.  

NOTE:  

This countermeasure is for "cranks, no start" only and NOT for "no Crank" incidents.

PARTS INFORMATION

CLAIMS INFORMATION

When applicable, standard claims coding applies.

Service Procedure

CHECK THE IGNITION TIMING AND THE BASE IDLE SPEED USING THE FOLLOWING PROCEDURE:
 
1.

Start engine and warm it up until engine coolant temperature indicator points to the middle of gauge.  Ensure engine speed remains below 1,000
rpm.

2.

Open hood and run engine at about 2,000 rpm for approximately 2 minutes under no-load.  Rev engine 2 or 3 times under no-load, then run engine
at idle speed for 1 minute.

Engine Controls - No Start At Low Ambient Temperature|Page 2428 > < Oxygen Sensor - Thread Cleaning and Other Precautions|Page 2416