Rogue 2WD L4-2.5L (QR25DE) (2008)
Keyless Entry Transmitter Battery: Service and Repair
Without Intelligent Key System
KEYFOB BATTERY
Exploded View
Exploded View DLK-501
Removal and Installation
REMOVAL
1. Remove screw (9) on the rear of keyfob.
2. Place the key with the lower case (8) facing up. Set a screw-driver wrapped with tape between upper case (1) and lower case (8) and then separate
the lower case (8) from the upper case (1).
CAUTION:
-
Do not touch the circuit board or battery terminal.
-
The keyfob is water-resistant. However, if it does get wet, immediately wipe it dry.
3. When replacing the circuit board assembly, remove circuit board assembly from the upper case (1). [Circuit board assembly: Switch rubber (4) +
Board surface (5)]
CAUTION: Do not touch the printed circuits directly.
4. Remove the battery (6) from the lower case (8) and replace it.
Battery replacement : Coin-type lithium battery (CR1620)
CAUTION: When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact area.
5. After replacement, fit the lower and upper cases together, part (4), (7) and tighten with the screw.
CAUTION: After replacing the battery, Be sure to check that door locking operates normally using the keyfob. Refer to DLK-365,
"Component Function Check". See: Testing and Inspection/Component Tests and General Diagnostics/Without Intelligent Key System/Keyfob
Battery
INSTALLATION
Install in the reverse order of removal.