Rogue 2WD L4-2.5L (QR25DE) (2008)
Submit a Primary Failed Part (PP) line claim using the claims coding table above.
SERVICE PROCEDURE
1.
Remove the console finisher assembly using a trim tool.
^
Refer to section IP in the Electronic Service Manual (ESM) for removal procedure.
2.
Cut 9 0.39" - 0.59" long x 0.19" wide (10-15 mm long x 5 mm wide) strips of the squeak and rattle tape.
3.
Using a needle nose plier, put tape from the squeak and rattle kit on the outer edge of the 9 ribs located underneath the upper half of the console
finisher assembly as shown in Figure 2.
NOTE:
Some models only have 7 ribs.
4.
Install the console finisher assembly in reverse order of removal.
5.
Check to make sure the issue has been resolved.
Disclaimer