Rogue 2WD L4-2.5L (QR25DE) (2008)
Wheel Speed Sensor: Service and Repair
ABS
Front
FRONT WHEEL SENSOR
BRC-66 Exploded View
NOTE: The above figure (front side) shows left side. Right side is the mirror image.
FRONT WHEEL SENSOR: Removal and Installation
REMOVAL
Pay attention to the following when removing sensor.
CAUTION:
^
Do not twist sensor harness as much as possible, when removing it. Pull sensors out without pulling sensor harness.
^
Take care to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before removing front or rear wheel hub. This is to
avoid damage to sensor wiring and loss of sensor function.
^
When you see the harness of the wheel sensor from the front side of the vehicle ensure that the yellow lines (A) are not twisted.
INSTALLATION
Pay attention to the following when installing wheel sensor. Tighten installation bolts to the specified torques.
^
When installing, make sure there is no foreign material such as iron chips on and in the mounting hole of the wheel sensor. Make sure no foreign
material has been caught in the sensor rotor. Remove any foreign material and clean the mount.
^
When installing wheel sensor, be sure to press rubber grommets in until they lock at locations shown above in the figure. When installed, harness
must not be twisted.
Rear
REAR WHEEL SENSOR