Rogue 2WD L4-2.5L (QR25DE) (2008)
Drive Belt Tensioner: Service and Repair
Removal and Installation
EM-24 Exploded View
Removal
CAUTION: The complete drive belt auto-tensioner must be replaced as a unit, including the pulley.
1. Remove front wheel and tire (RH).
2. Remove front fender protector (RH).
3. Remove drive belt.
4. Support the bottom surface of engine using a transmission jack, and loosen engine mounting insulator bolts (RH).
CAUTION: Never remove the bolts (No. 4, 5) as shown in the figure.
<---: Engine front
5. Remove idler pulley.
6. Release the fixed drive belt auto-tensioner pulley.
7. Remove drive belt auto-tensioner.
CAUTION: Never loosen the hexagonal part in center of drive belt auto-tensioner pulley (Never turn it counterclockwise). If turned
counterclockwise, the complete drive belt auto-tensioner must be replaced as a unit, including the pulley.
Installation
Note the following, and install in the reverse order of removal.
CAUTION: