Rogue 2WD L4-2.5L (QR25DE) (2008)
a. Loosen bolts in reverse order as shown in the figure.
<---: Engine front
b. Insert seal cutter (SST) between oil pan (upper) and lower cylinder block, and slide it by tapping on the side of the tool with a hammer.
CAUTION: Be careful not to damage the mating surface.
13. Remove O-rings at front cover side.
INSTALLATION
1. Install oil pan (upper) with the following procedure:
a. Use a scraper to remove old liquid gasket from mating surfaces.
^
Also remove the old liquid gasket from mating surface of cylinder block.
^
Remove old liquid gasket from the bolt holes and threads.
CAUTION: Never scratch or damage the mating surfaces when cleaning off old liquid gasket.