Rogue 2WD L4-2.5L (QR25DE) (2008)
Air Bag Control Module: Service and Repair
For USA and Canada
DIAGNOSIS SENSOR UNIT
Exploded View
Exploded View SR-18
Removal and Installation
WARNING:
-
Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes.
-
Before disconnecting the air bag sensor unit harness connector, be sure to disconnect the each harness connector of the air bag module
and pre-tensioner seat belt to prevent air bag deployment by static electricity and pre-tensioner seat belt operation.
-
Do not use air tools or electric tools for servicing.
REMOVAL
1. Disconnect each connector of all air bag modules and pre-tensioner seat belts.
2. Remove the center console assembly.
3. Disconnect diagnosis sensor unit harness connectors.
4. Remove fixing bolts, ground bolt, and then remove diagnosis sensor unit.
CAUTION:
-
Replace the diagnosis sensor unit if it has been dropped or sustained an impact.
-
Do not use old fixing bolts after removal; replace with new fixing bolts.
-
Replace the diagnosis sensor unit of deployed SRS air bag and deployed SRS front seat belt pre-tensioner.
INSTALLATION