Rogue 2WD L4-2.5L (QR25DE) (2008)
Transmission Speed Sensor: Service and Repair
Primary Speed Sensor
PRIMARY SPEED SENSOR
TM-191 Exploded View
Removal and Installation
REMOVAL
1. Disconnect the battery cable from negative terminal.
2. Disconnect primary speed sensor connector (A).
3. Remove primary speed sensor.
4. Remove O-ring from primary speed sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
^
Never reuse O-ring.
^
Apply CVT fluid to O-ring.
Inspection
After completing installation, check for CVT fluid leakage and check CVT fluid level. Refer to TM-160, "Inspection". See: Service and
Repair/Procedures/Inspection