Rogue 4WD L4-2.5L (QR25DE) (2009)
-
If quick connector sticks to tube of main fuel level sensor unit, push and pull quick connectors several times until they start to move. Then
disconnect them by pulling.
CAUTION:
-
Quick connector (1) can be disconnected when the tabs (F) are depressed completely. Never twist it more than necessary.
-
Never use any tools to disconnected quick connector.
-
Keep resin tube (C) away from heat. Be especially careful when welding near the resin tube.
B : Connection (cross-section)
D : To under floor fuel line
E : To fuel tank
G : Disconnection
-
Prevent acid liquid such as battery electrolyte, etc. from getting on resin tube.
-
Never bend or twist resin tube during installation and disconnection.
-
Never remove the remaining retainer (2) on hard tube (or the equivalent) (A) except when resin tube or retainer is replaced.
-
When resin tube or hard tube (or the equivalent) is replaced, also replace retainer with new one.
Retainer color : White
-
To keep the connecting portion clean and to avoid damage and foreign materials, cover them completely with plastic bags (A) or
something similar.
8. Using lock ring wrench [SST: KV991J0090 (J-46214)] (A), remove lock ring.