Sentra L4-1.8L (QG18DE) (2004)
/Page-1288016.png)
A.
On the ASIST screen, click on "Transfer" (see Figure 10).
^
Data transfer should take less than two minutes.
^
Transfer progress is displayed on the ASIST screen (see Figure 10).
B. Wait until the data transfer is complete (see CAUTION above).
11.
When transfer is complete (see Figure 11):
A.
Select (click on) "Okay", then "MAIN MENU".
B.
Turn "OFF" CONSULT-II.
C.
Disconnect the AC power cord and the Ethernet cable from CONSULT-II.
DOWNLOAD NEW DATA FROM CONSULT-II INTO THE VEHICLE (REPROGRAM ECM)
CAUTION:
^
Perform this operation in four (4) sections. DO NOT SKIP any of these sections.
^
They must be performed in order, 1 through 4.
Section 1: Connect a battery charger and CONSULT-II to the vehicle.
Section 2: Confirm the vehicle battery voltage and CONSULT-II "Charger Input".
Section 3: Perform ECM Reprogramming.
Section 4: Perform ECM Reprogram Confirmation.
Section 1: Connect a battery charger and CONSULT-II to the vehicle.
12.
First, confirm the ignition switch is "OFF".
