Sentra L4-1.8L (QG18DE) (2004)
C.
Touch [SET DATE] (see Figure 2).
1)
If the date is not correct, touch the [MONTH], [DAY] or [YEAR] as needed. Then adjust it by using arrow keys. Once done, press
[SAVE], press [BACK], and go to step D.
2)
If the date is OK, press [BACK] and go to step D.
D.
Touch [SET TIME] (see Figure 2).
1)
If time is not correct, touch the [HOUR], [MINUTE] or as needed. Then adjust it by using arrow keys. After you are done, press
SAVE, press [BACK] and go to step 5.
2)
If time is OK, press [BACK] and go to step 5.
IMPORTANT NOTE
^
If your ASIST PC is already set up for ECM reprogramming, proceed to step 5.
^
If you are unsure whether your ASIST PC has already been set up for ECM reprogramming, look in ASIST, under "CONSULT Utilities" -
"CONSULT-II Info - "NISSAN" - "ECU Reprogramming". This will give you instructions for setting the Ethernet (IP) Address of the
ASIST PC and CONSULT-II. You will need to do this before performing ECM reprogramming.
DOWNLOAD (TRANSFER) DATA FROM ASIST INTO CONSULT-II