Sentra L4-1.8L (QG18DE) (2004)
B. Touch [SUB MODE].
C. Touch [SET DATE] (see Figure 2).
1) If the date is not correct, touch the [MONTH], [DAY] or [YEAR] as needed. Then adjust it by using arrow keys. Once done, press [SAVE],
press [BACK], and go to step D.
2) If the date is OK, press [BACK] and go to step D.
D. Touch [SET TIME] (see Figure 2).
1) If time is not correct, touch the [HOUR], [MINUTE] or [AM/PM] as needed. Then adjust it by using arrow keys. Once done, press [SAVE],
press [BACK] and go to step 5.
2) If time is OK, press [BACK] and go to step 5.
IMPORTANT NOTE:
^ If your ASIST PC is already being used to perform ECM Reprogramming, proceed to step 5 below.
^ If you are unsure whether your ASIST PC has already been set up for ECM Reprogramming, look in ASIST, under "CONSULT Utilities" -
"CONSULT-II Info" - "NISSAN" - "ECU Reprogramming". This will give you instructions for setting the Ethernet (IP) Address of the ASIST PC and
CONSULT-II. You will need to do this before performing ECM reprogramming.
DOWNLOAD (TRANSFER) DATA FROM ASIST INTO CONSULT-II