Sentra L4-1597cc 1.6L SOHC (E16S) (1985)
Distributor Cap: Customer Interest
Ignition - Hesitation During Warm-Up, Wet/High Humidity
Reference:
Date:
TECHNICAL BULLETIN
TS86-004
January 21, 1986
Classification:
Section: Models: 1985 300ZX, Stanza, Sentra
EE86-001
Engine Electrical
and Pulsar NX
HARD START AND ENGINE HESITATION
APPLIED MODELS: 1985 300ZX, Stanza, Sentra and Pulsar NX
SERVICE INFORMATION
Some of the Applied Models may experience a hard start condition or engine hesitation during warm-up. This is most likely to occur in wet or high
humidity conditions. When these conditions exist, perform the following Service Procedure.
AFFECTED ENGINE NUMBERS:
MODEL
ENGINE NUMBER RANGE
300ZX
VG30-237552 to VG30-365717
CA20-214475A to CA20-270131A
Stanza
AND
CA20-100923B to CA20-144274B
E16-001001A to E16-053635A
Sentra/Pulsar NX
AND
E16-491103 to E16-711337
DISTRIBUTOR CAP
SERVICE PROCEDURE
1.
Check the distributor cap for a letter "S" stamped next to the Hitachi trademark as shown below.
2.
If the cap does not have the letter "S" and the engine number is within the affected engine number range shown on page 1/2, replace the cap with a
new cap listed in the Parts Information of this bulletin.
3.
If the cap does have the letter "S" and the engine number is not within the affected engine number range or if the above procedure does not correct
the condition, refer to the EF & EC section of the appropriate Service Manual for driveability diagnosis and Technical Bulletin EF85-XXX, "Use
of Methanol and Gasoline Antifreeze".
PARTS INFORMATION
MODEL
PART DESCRIPTION
NEW PART NUMBER
300ZX
Distributor Cap
22162-12P04
Stanza
Distributor Cap
22162-D3302