Sentra L4-2.0L (MR20DE) (2010)
Brake Proportioning/Combination Valve: Removal and Replacement
DUAL PROPORTIONING VALVE
Removal and Installation
Removal
CAUTION:
Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on paint areas, wash it away with
water immediately.
1. Drain the brake fluid. See: Brake Fluid/Service and Repair/Removal and Replacement.
2. Disconnect brake lines from dual proportioning valve.
-
Mark brake lines for installation.
3. Remove dual proportioning valve bolt and dual proportioning valve.
4. Remove two bolts and bracket.
Installation
Installation is in the reverse order of removal.
-
When installing brake lines to the dual proportioning valve, tighten to specifications. See: Diagrams.
-
Refill and bleed the brake system. See: Brake Bleeding/Service and Repair.
CAUTION:
-
Carefully monitor brake fluid level at master cylinder.
-
Use the recommended new brake fluid.
-
Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on paint areas, wash it away
with water immediately.