Sentra L4-2.0L (MR20DE) (2010)
NG - Replace stop lamp switch.
15.CHECK INTERMITTENT INCIDENT
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Trouble Diagnosis
For Intermittent Incident/Description/Except For California See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Trouble Diagnosis For Intermittent Incident/Diagnosis Procedure/Except For California.
- INSPECTION END
For California
ASCD BRAKE SWITCH
Component Inspection
ASCD BRAKE SWITCH
1. Turn ignition switch OFF.
2. Disconnect ASCD brake switch harness connector.
3. Check continuity between ASCD brake switch terminals 1 and 2 under the following conditions.
If NG, adjust ASCD brake switch installation, See: Brakes and Traction Control/Brake Pedal Assy/Service and Repair/Inspection and Adjustment,
and perform step 3 again.
ASCD CLUTCH SWITCH
1. Turn ignition switch OFF.
2. Disconnect ASCD clutch switch harness connector.
3. Check continuity between ASCD clutch switch terminals 1 and 2 under the following conditions.
If NG, adjust ASCD clutch switch installation, See: Transmission and Drivetrain/Clutch/Clutch Pedal Assembly/Adjustments, and perform step 3
again.
STOP LAMP SWITCH
1. Turn ignition switch OFF.