Sentra L4-2.0L (MR20DE) (2010)
/Page-455065.png)
Is the measurement value within the specification?
YES - GO TO 3.
NO - Repair the TCM branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the TCM. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/P
Code Charts/P1701.
Is the inspection result normal?
YES (Present error)-Replace the TCM. See: Transmission Control Systems/Relays and Modules - Transmission and Drivetrain/Relays and Modules -
CVT/Control Module/Service and Repair.
YES (Past error)-Error was detected in the TCM branch line.
NO - Repair the power supply and the ground circuit.
CAN System (Type 8)
TCM BRANCH LINE CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
-
TCM
-
Harness connector F10
-
Harness connector E17
Is the inspection result normal?
YES - GO TO 2.
NO - Repair the terminal and connector.
2.CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect the connector of TCM.
2. Check the resistance between the TCM harness connector terminals.
Is the measurement value within the specification?
YES - GO TO 3.
NO - Repair the TCM branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the TCM. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/P
Code Charts/P1701.
Is the inspection result normal?
YES (Present error)-Replace the TCM. See: Transmission Control Systems/Relays and Modules - Transmission and Drivetrain/Relays and Modules -
CVT/Control Module/Service and Repair.
YES (Past error)-Error was detected in the TCM branch line.
NO - Repair the power supply and the ground circuit.
CAN System (Type 10)
TCM BRANCH LINE CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
-
TCM
-
Harness connector F10
