Sentra L4-2.0L (MR20DE) (2010)
Accelerator Pedal Position Sensor: Service and Repair
Removal and Installation
ACCELERATOR CONTROL SYSTEM
Removal and Installation
CAUTION:
-
Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sensor from accelerator pedal assembly.
-
Avoid impact from dropping etc. during handling.
-
Be careful to keep accelerator pedal assembly away from water.
REMOVAL
1. Disconnect the negative battery terminal.
2. Disconnect accelerator pedal position sensor harness connector.
3. Remove the accelerator pedal assembly nuts and remove accelerator pedal assembly.
INSTALLATION
Installation is in the reverse order of removal.
-
Check the accelerator pedal for smooth operation. There should be no binding or sticking when applying or releasing the accelerator pedal.
-
Check that the accelerator pedal moves through the full specified distance of the specified pedal travel (A).
Pedal Travel (A) : 50.5 mm (1.99 in)
CAUTION:
-
When the accelerator pedal position sensor harness connector is disconnected, perform the "Accelerator Pedal Released
Position Learning". See: Computers and Control Systems/Engine Control Module/Testing and Inspection/VIN Registration/For California
See: Computers and Control Systems/Testing and Inspection/Programming and Relearning/Accelerator Pedal Released Position
Learning/For California See: Testing and Inspection/Programming and Relearning/Throttle Valve Closed Position Learning/For California
See: Testing and Inspection/Programming and Relearning/Idle Air Volume Learning/For California, See: Computers and Control
Systems/Testing and Inspection/Programming and Relearning/Accelerator Pedal Released Position Learning/Except For California
(MR20DE Except For California), See: Computers and Control Systems/Testing and Inspection/Programming and Relearning/Accelerator Pedal
Released Position Learning
(QR25DE).