Sentra L4-2.0L (MR20DE) (2010)
Seals and Gaskets: Service and Repair
Side Oil Seal
SIDE OIL SEAL
Removal and Installation
REMOVAL
1. Remove front drive shafts from transaxle assembly. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and
Replacement/Removal and Installation (Left Side) and See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
and Replacement/Removal and Installation (Right Side).
2. Remove differential side oil seal (1) using a suitable tool.
CAUTION:
Be careful not to damage transaxle case and clutch housing.
INSTALLATION
Installation is in the reverse order of removal.
-
Install differential side oil seal (1) to clutch housing and transaxle case using Tool.
CAUTION:
Do not reuse oil seal.
Tool number : KV32500QAA (B.vi 1666-B)
-
A: Transaxle case side
-
B: Clutch housing side
CAUTION:
-
Never incline differential oil seal.
-
Never damage clutch housing and transaxle case.
-
Check oil level after installation. See: Fluid - M/T/Service and Repair/Checking M/T Oil.