nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Crankshaft Position Sensor|Diagrams|Adjustments|Page 8967 > < Crankshaft Position Sensor|Diagrams|Adjustments
Page 1
background image

Vehicle: Vehicle Damage Warnings

Supplemental Restraint System (SRS) "Air Bag"

The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER" used along with a seat belt, helps to reduce the risk or
severity of injury to the driver and front passenger for certain types of collision. The SRS system composition which is available to NISSAN MODEL
B15 is as follows:

For a Frontal Collision

The Supplemental Restraint System consists of driver air bag module (located in the center of the steering wheel), front passenger air bag module
(located on the instrument panel on passenger side), front seat belt pre-tensioners, a diagnosis sensor unit, warning lamp, wiring harness and spiral cable.

For a Side Collision

The Supplemental Restraint System consists of front side air bag module (located in the outer side of front seat), side air bag (satellite) sensor, diagnosis
sensor unit (one of components of air bags for a frontal collision), wiring harness, warning lamp (one of components of air bags for a frontal collision).

WARNING:

-

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would
result in air bag inflation, all maintenance should be performed by an authorized NISSAN dealer.

-

Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional
activation of the system.

-

Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. Spiral cable and wiring
harnesses covered with yellow insulation tape either just before the harness connectors or for the complete harness are related to the
SRS.

General Precautions

-

Do not operate the engine for an extended period of time without proper exhaust ventilation.
Keep the work area well ventilated and free of any inflammable materials. Special care should be taken when handling any inflammable or
poisonous materials, such as gasoline, refrigerant gas, etc. When working in a pit or other enclosed area, be sure to properly ventilate the area
before working with hazardous materials.
Do not smoke while working on the vehicle.

Crankshaft Position Sensor|Diagrams|Adjustments|Page 8967 > < Crankshaft Position Sensor|Diagrams|Adjustments