Sentra Hatchback Coupe L4-1597cc 1.6L SOHC (E16i) (1987)
1.
Remove rear seat.
2.
Remove rear shock absorber caps and wheelhouse finishers. It is recommended that the shock absorber caps are replaced with retro-fit caps listed
in the parts information section.
3.
Remove rear pillar finishers.
4.
Locate the drilling point which is factory pre-scribed in the rear pillar finishers.
5.
Using a 1" hole saw, drill the finisher at the marked location.
6.
Remove original lap belts (female buckle side).
7.
Install female buckle lap belts from retro-fit kit. Torque mounting bolts to 26-32 ft.lbs. (3.65-4.65 kg/m).
8.
Remove the retracting side of the original lap belts.
9.
The retracting side of the retro-fit lap belt is installed in two steps. First, install the retractor unit end of the shoulder harness. Then place the
wheelhouse finisher and retro-fit shock absorber cap into position. Bolt the shoulder anchor into the rear side panel where the 1" hole was drilled.
NOTE:
Anchor/mounting bolt torque is 26-32 ft.lbs. (3.65-4.65 kg/m).
10.
Fully tighten the wheelhouse panel finishers.
11.
Check the retro-fit lap belts for smooth operation.
12.
Reinstall rear seat.
Pulsar