nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Customer Interest for Wiring Harness: > < Accessory Relay|Page 4866
Page 1
background image

Wiring Harness: All Technical Service Bulletins
Main Harness - Ground Wire Overheating

Reference:

Date:

TECHNICAL BULLETIN TS87-133

August 24, 1987

Classification:

Section:             Models:

EL87-015

Electrical System

1987 Pulsar NX & 4WD Sentra Wagon

MAIN HARNESS GROUND WIRE

APPLIED MODELS:

1987 Pulsar NX (N13) 1987 4WD Sentra Wagon (B12)

SERVICE INFORMATION

Some 1987 Pulsar NX and 1987 4WD Sentra Wagon vehicles with the E16i engine, may experience an overheated ground wire in the main harness,
between the mixture heater (connector 43M) and the body ground (connector 31M). The routing of this ground wire is shown below.
If this incident occurs, remove the mixture heater and check the bottom side for signs of damage to the heater grid. If any damage is found, replace the
mixture heater. If necessary, repair or replace the damaged harness.
PARTS INFORMATION

PART NAME

PART NUMBER

Insulator (Mixture Heater)

16174-69A10

WARRANTY INFORMATION

Refer to Section GB or PA of the Warranty Flat Rate Manual.

Customer Interest for Wiring Harness: > < Accessory Relay|Page 4866