Sentra SE-R Spec V L4-2.5L (QR25DE) (2002)
Brake Pad: Service and Repair
Rear
Pad Replacement
WARNING: Clean brake pads with a vacuum dust collector to minimize the hazard of airborne particles or other materials.
CAUTION:
-
When cylinder body is open, do not depress brake pedal because piston will pop out.
-
Be careful not to damage piston boot or get oil on rotor. Always replace shims in replacing pads.
-
If shims are rusted or show peeling of rubber coat, replace them with new shims.
-
It is not necessary to remove connecting bolt except for disassembly or replacement of caliper assembly. In this case, suspend cylinder body with
wire so as not to stretch brake hose.
-
Burnish the brake contact surfaces after refinishing or replacing drums or rotors, after replacing pads or linings, or if a soft pedal occurs at very
low mileage.