Sentra SE-R Spec V L4-2.5L (QR25DE) (2002)
7. Remove knuckle from lower ball joint stud with Tool.
Installation
1. Install in reverse order of removal.
-
Install knuckle with wheel hub.
When installing knuckle to strut, be sure to hold bolts and tighten nuts.
: 114 - 133 Nm (11.6 - 13.6 kgf-m, 84 - 98 ft. lbs.)
Before tightening, apply oil to threaded portion of drive shaft.
-
Tighten wheel bearing lock nut.
: 197 - 274 Nm (20 - 28 kgf-m, 145 - 202 ft. lbs.) (QG18DE models)
: 255 - 333 Nm (26 - 33 kgf-m, 188 - 245 ft. lbs.) (QR25DE models)
-
Rotate wheel hub to check that wheel bearings operate smoothly.
-
Rotate wheel hub to check wheel bearing axial end play.
Axial end play: 0.05 mm (0.0020 inch) or less
Rear