Sentra Sedan L4-1597cc 1.6L SOHC (E16S) (1986)
Technical Service Bulletin # BF90007
Date: 900607
Seat Belts - Installation of 3-Point Rear Belts
Classification:
Section:
BF90-007
Body & Frame
Reference:
TECHNICAL BULLETIN NTB90-049
Models:
1982-86 Sentra Date:
June 7, 1990
SENTRA 3-POINT REAR SEAT BELT INSTALLATION
APPLIED MODELS:
1982-86 Sentra Sedan (B11) 1982-86 Sentra Coupe (B11) 1982-86 Sentra Wagon (B11)
SERVICE INFORMATION
This bulletin describes 3-point rear seat belt installation procedures for the applied models listed above. These vehicles are already equipped with
threaded fittings for installation of the 3-point belts. However, in most cases, it will be necessary to modify or replace certain trim pieces to complete the
installation. Trim modification requires cutting/drilling of the quarter panel trim and, in the case of the sedan, the rear parcel shelf.
Please make these instructions available to customers who purchase retrofit kits and choose to install the belts themselves. Ensure that a copy of the child
seat installation instructions are provided to customers for every installation (dealer or DIY).
PARTS INFORMATION
The replacement parts necessary to complete the installation on each model are listed on page 13 of this bulletin.
CHILD RESTRAINT INSTALLATION WITH REAR 3-POINT SEAT BELTS
Outboard shoulder/lap belt
Before using the locking clip, read the instructions attached to the clip.
Secure the child restraint with the lap belt as illustrated. To prevent slack in the lap belt, it will be necessary to secure the lap/shoulder belt in place with
a locking clip.
Use a genuine locking clip (part number; H8010-89970, available from your NISSAN dealer), or one which is the same in dimension and strength.
When your child restraint system is not in use, keep the locking clip in the glove box to prevent it from being lost.
2/4-Door Sedan
1.
Remove rear lower seat cushion.