Sentra Sedan L4-1597cc 1.6L SOHC (E16S) (1986)
/Page-994004.png)
FIGURE 7
9.
Cut the urethane applicator tip at an angle. Only about 1/3 of the tip head should be cut away to allow for proper sealant distribution. Apply a bead
of adhesive around the perimeter of the windshield (Figure 7).
FIGURE 8
10.
Set the glass in place, pressing lightly and evenly around the edges.
11.
After the windshield is in place, apply additional urethane adhesive along the windshield bottom edge making sure that it fills the cracks around
the original adhesive (Figure 8).
FIGURE 9
12.
Make a 2nd pass to widen the base and cover the edge and surface (2 mm) of the windshield (Figure 9) Adhesive should extend at least 5 mm
outside the edge of the windshield.
13.
Water test the windshield using the procedure found in the appropriate model Service Manual.
14.
Install the windshield moldings.
15.
Install the windshield wipers. Be certain to follow all special cautions found in the appropriate model Service Manual when installing the wipers.
16.
Test wiper operation to ensure that they function properly.
