Sentra XE L4-1.8L (QG18DE) (2000)
Housing alone cannot be replaced. It must be replaced together with spider assembly.
DS83 Type
-
Replace any parts of double offset joint which show signs of scorching, rust, wear or excessive play.
-
Check serration for deformation. Replace if necessary.
-
Check slide joint housing for any damage. Replace if necessary.
Joint Assembly (Wheel side)
Replace joint assembly if it is deformed or damaged.
Support Bearing
Make sure support bearing rolls freely and is free from noise, cracks, pitting and wear.
Support Bearing Bracket
Check support bearing bracket for cracks with a magnetic exploration or dyeing test.
ASSEMBLY
-
After drive shaft has been assembled, ensure that it moves smoothly over its entire range without binding.
-
Use NISSAN GENUINE GREASE or equivalent after every overhaul.
Support Bearing
1. Install bearing into retainer.
2. Install dust shield.
3. Install snap ring.
4. Press drive shaft into bearing.