Stanza L4-2389cc 2.4L SOHC MFI (KA24E) (1991)
/Page-957011.png)
CAUTION:
Do not tighten the plate bolts after the adhesive is dry.
12.
From outside the vehicle through the fuel filler hole, use Lord(R) Chemicals Fusor(R) Urethane Sealer/Adhesive P/N 800 to completely cover the
hole around the weld nut. Do not cover the weld nut.
13.
After the anchor plate adhesive dries, remove the clamps. Use the urethane sealer around the entire perimeter of the plate. Use a brush to smooth
the sealer for good seam coverage.
14.
After the seam sealer has skinned-over, install the new fuel filler tube as outlined in Fuel Filler Tube Installation. It may be necessary to re-seal any
area disturbed by the fuel filler tube installation. Reinstall the fuel filler tube protective cover.
15.
Install the wheel. Torque the bolts to 72-87 ft-lb (98-118 N.m). Lower the vehicle.
16.
Do not install, but keep in the vehicle:
^
Seat belt anchor bolt and spacer
^
Trunk finisher
^
Trunk carpet
^
Retractor cover
^
Original fuel filler tube in the plastic bag and cardboard box for dealer pan retention.
17.
Prepare the vehicle for delivery back to the dealer.
Operation 5 Replace Complete Wheel House
Kits Required: Kit A, Inner and Outer Wheel House Panels & Strut Mounting Bolt Nuts
1.
From inside the trunk remove:
^
All trim/finishers
^
The spare tire, jack, etc.
^
The anchor bolt for the left rear seat belt retractor.
2.
From inside the rear cabin remove the:
^
Rear seat and cushion
^
High-mounted stop lamp
^
Parcel shelf board
^
Bolts that secure the left rear seat belt and remove the seat belt assembly
^
Weather strips
^
Rear pillar garnishes
^
Left and right rear plastic kick plates
^
Rear speakers
^
Rear amplifier, if equipped
^
ABS control unit, if equipped
3.
On the Stanza only, remove the rear bumper.
4.
To remove the left rear suspension struts and control arms, remove the following:
